Step 1: Draw a line

A good start is always important. Draw a vertical line to identify where your first panel should be. Measure out from the left corner of the wall by using the tape measure, mark the width of the panel, and draw a straight line with the level.

Step 2: Peel

A good start is always important. Draw a vertical line to identify where your first panel should be. Measure out from the left corner of the wall by using the tape measure, mark the width of the panel, and draw a straight line with the level.

Step 3: Apply

Apply your panel, start from the corner and work your way down, lining up along the line you just drew.

Step 4: Smooth out

Use your smoother/putty knife to smooth out all the bubbles and creases, always start from the centre.

Step 5: Trim

Cut the edge and any extra bits and parts.

Step 6: Apply next Panel

Match the patterns on the edge and it is okay to leave extra bits on the top, you can trim it later.

Step 1: Prepare yourself

Wallpaper, Ladder, Spirit Level, Smoother/Putty Knife, Utility Knife, Tape Measure, Pencil, Paste, Brush, Roller Tray, Stirrer, Bucket, Water

Step 2: Draw a line

A good start is always important. Draw a vertical line to identify where your first panel should be. Measure out from the left corner of the wall by using the tape measure, mark the width of the panel, and draw a straight line with the level.

Step 3: Mix Paste

Follow instructions on the wallpaper paste package, mix wallpaper paste with water. Stir.

Step 4: Pour Paste

Pour your mixed paste to your roller tray.

Step 5: Paste your wall

Use your roller and paint brush to get your paste onto the wall. Use a paint brush to get into the corners, and a roller to roll the remainder of the wall to get even coverage. Work from the corner out to the level line you just drew.

Step 6: Apply

Apply your panel, start from the corner and work your way down, lining up along the line you just drew.

Step 7: Smooth out

Use your smoother/putty knife to smooth out all the bubbles and creases, always start from the centre.

Step 8: Trim

Cut the edge and any extra bits and parts.

Step 9: Paste again

Paste your wall for your next panel.